Above 400mm Pipe Size

STANDARD RESIN / GLASS TAPE	PRINT THIS PAGE

Simply follow the procedure detailed below to quickly and effectively do the repair

• Mix and Apply the Resin & Hardener (TRK19000)
• Wrap the Glass Tape with 50% Overlap (TRK19007/9)
• Apply the Resin & Hardener over the tape and Wrap the Glass Tape again.
• Repeat this three times finishing with a coating of Resin & Hardener

QUICK APPLICATION GUIDE

• prepare surface
• mix and apply resin & hardener to pipe repair area (leaving a minimum overlap of 80mm each side of the repair)
• wrap glass tape with a 50% overlap (don't cut the tape)
• reapply resin & hardener
• wrap glass tape back to beginning of the repair with a 50% overlap (don't cut the tape)
• reapply resin & hardener
• wrap glass tape back to end of repair and cut
• reapply resin and hardener over all the repair

SURFACE PREPARATION

The pressure within the system to be repaired must be turned off and all product allowed to drain away, leaving a dry surface around the damaged area. Using a wire brush or coarse sandpaper the area to be repaired must be cleared of any loose material and rust. Once abraded the damaged area must be cleaned using ThistleBond Universal Cleaners.

APPLICATION TECHNIQUE

Repair to pipe work – ThistleBond Standard Resin and Hardener can be used on any diameter pipe work. Mix the tin of resin thoroughly and brush onto the damaged surface, ensure the Resin exceeds the damaged area by a minimum of 3”. Wind the Glass Tape roll around the pipe work, overlapping the tape by 50%, once you have reached the end of the repair do not cut the tape. Brush more resin over the glass tape and begin to wind the glass tape of the first layer of glass tape. Repeat this application up to 4 times depending on the pressure tolerance required.

Repair to leaking tank seam- Before applying the Resin and Hardener measure the surface are to be repaired and cut three areas of Glass Mat for the repair, ensure that the Glass Mat exceeds the surface of the repair by 3” in all directions. Mix the ThistleBond Standard Resin and Hardener thoroughly and brush onto the surface of the damaged area. Lay one layer of the Glass Mat onto the applied Resin and hardener, then using a stiff bristled brush, apply more of the mixed product to the surface of the Glass Mat. Ensure the Matting is thoroughly soaked with Resin. Repeat this application three times and then allow the product to fully cure.

a "One Stop Solution" to ALL your pipe leakage problems